LEDs are designated by four-digit codes such as 3528, 5050, 5060, and 2835. The first two digits refer to the width of the chip, while the last two digits refer to its length, in tenths of a millimeter. So, a 5060 LED for example, has a width of 5.0 mm, and a length of 6.0 mm.

The abbreviation “SMD” preceding these numbers refers to a 'Surface Mounted Device'.

Highlights:

 DEMASLED´s blue (465-470nm) SMD 5060 chip has a low power consumption of 0.18W per chip, they provide  per chip (800 MCD) and a 120° beam angle. Both aspects are ideal for to create the perfect high-intensity light settings.

 SMD 5060 Chips are just barely behind the 3528 chips in popularity. However, 5060 chips are typically 3 times brighter than 3528 chips. Because they're brighter, strips with 5060 chips are typically used for what is known as "task lighting", and are commonly used underneath kitchen cabinets where that high-intensity light will help you see what you're doing. 

How to use:

To solder the SMD LEDs, follow these steps:

• Apply light flux on the surface to be welded.
• At the two contact points, place a small layer of tin.
• Locate the resistance at the point of contact.
• Apply another layer of tin to the other end of the resistor.

Tips before buying:

 If you wish to compare LED strip lighting between different suppliers, if the strips are using the same chips, look at how many LEDs are on the strip and the lumen´s output to determine brightness.  Pay attention to how many LEDs there are per foot or meter. 

 When searching for bright LED strip lights, make sure you compare same technical and quality parameters, not all LED strips are made in the same way and with the same data specs.

 If you have doubts about the LED chips you need for your projects, please contact our FREE TECH SUPPORT TEAM