NILA

Straw Hat Through-Hole LED, Yellow 5mm, 3lm 2V 100mW 20mA

    Unit price

    • $0.05
    For Wholesale prices, please contact us: +34 629.208.726 from Monday to Friday, from 9:00am to 5:00pm (GMT+1) or through jorge@aspentrade.com
* Prices do not include TAX. ** All prices updated to 29/03/24.
Working Current 20 mA
Color Yellow   
Wavelength (±5nm) 590 nm
Beam Angle 120 °
Luminous Flux 2 lm
Luminous Flux per Chip 750 mcd
Luminous Efficacy 20 lm/W
Dimmable? Yes   
Operating Temperature -22 ~ 176 °F
Storage Temperature -22 ~ 176 °F
Lifespan 50000 h
Diameter 0.19 in
Length 1.37 in

The straw hat LEDs are similar to the traditional 5mm LEDs but the design of their dome, being a little more rounded, means that they can offer a better light aperture angle: 120 degrees, achieving a homogeneous dispersion of light. They are also called Helmet Cup LED.

These 5mm LEDs are encapsulated in a transparent resin dome whose utility is to protect the light emitter, they contain three pieces: reflector cup, semiconductor, and conductive wire. Two legs extend below-said dome: the longest is of positive polarity and is called the anode, the shortest is of negative polarity and is called the cathode. These pins will indicate the way the LED should be connected to the circuit.

These high brightness LEDs due to their highly reflective design with primary optics and their high brightness range (750 mcd) reflect bright yellow light (3000K°), making them quite visible. Thanks to their diameter of 5mm, they are compatible with any type of Porta LED of that size. 

They have a lower height than the traditional 5mm LED, so they are very useful when it comes to achieving lighting effects in small spaces. Its 120-degree aperture manages to create wider lighting effects, ideal for places where light needs to be scattered. Being narrower than traditional LEDs, they can easily fit into tight spaces.

 

enlightenedHow do they work?:

LEDs can be used in three different ways:

  • Individual: direct LED power from the power supply, either by means of a regulated source or with the use of resistors or regulators. The desired voltage must be supplied to the LED within the working values.

  • Parallel configuration: powering a group of LEDs connecting all the anodes together and all the cathodes together, using the required voltage regulated by a single resistor in series.

  • Series configuration: powering a group of LEDs connected sequentially. The number of LEDs to be used per series will be limited by the voltage delivered by the power supply. In most cases, a resistor is required to compensate for the differences in supply voltage per LED series, being able to carry out different series in parallel with the same power supply.

* Prices do not include TAX. ** All prices updated to 29/03/24.
Contactanos por Whatsapp

Contact us

from 9 a.m. to 6 p.m.